AIO FTS

Convert all STS scopes to FTS and make them independent createables.

Author's words:

Converts all applicable scopes from SailentPhantom's MK18 Armory Item 2/3 to FTS and provides riser card support for most scopes. To add an adapter card to a scope, select the [Sights] accessory under the [Sights] section. Supported riser FTS sights are located in the weapons workbench menu under [FTS riser sights].

All range settings can be adjusted to personal preference in the FTS overlay menu. The scope is zeroed without modifying the riser, if a riser is used the overlay position must be readjusted.

Require:

MK18 CQBR

MK18 Armory Project

MK18 Armory Project 2

MK18 Armory Project 3

FTS Framework 0.9.4

Known issues:

The FTS overlay may not initially appear on the modded weapon, if this happens, re-equip the scope in the weapon workbench and it should fix it. (This may be a script lag issue with the FTS framework, I haven't encountered this issue with other FTS patches.)

Unable to get the non-legacy mode of the scope to work on the NOVESKE receiver type (I don't know why that is..), if you must use a NOVESKE receiver, ticking the legacy mode in the FTS overlay menu works, but the overlay must be re-viewed, and the quality is not the same as the non-legacy mode. Adjusting scope settings will carry over to all other receivers, as these settings are associated with individual miscellaneous modifications.

• I can make a whole set of standalone scopes for NOVESKE if needed.

If using discord's MK18 Side Aim Redux Patch, you must load all Side Aim patch .esp after my FTS patch for Side Aim to function properly.

If you are having issues with overlays not showing up, make sure you have FTS v0.9.4 and ALL requirements installed. The load order should be

-=LO example=-

(if used) - SideAim.esp

MK18.esp

STS for MK18 Armory Project 1-3.esp (3dscope-replacer.esp)

FTS.esp

MK18 Armory Project AIO FTS Patch.esp

(if used) - MK18_SA_Patch.esp