LoadAccelerator

Fallout 4 is loading very slowly. The fundamental way to solve this problem is to install an SSD solid state drive. This tool can only play a certain role.

The principle of the tool is very simple, it is to speed up the loading speed by controlling vertical synchronization. Only turn off vertical synchronization in the reading interface to get the acceleration effect.

Put [D3D11.dll] and [LoadAccelerator.ini] in the folder where Fallout4.exe is located.

• If you turn on vertical synchronization in the graphics card settings panel, please cancel it (let the program control it)
• If you have turned off vertical synchronization in Fallout4Prefs.ini, please change it back (iPresentInterval = 1)
• The program will turn off vertical synchronization in the game loading interface, and a prompt will appear in the lower right corner of the screen.

If it doesn't work

Since everyone’s specific circumstances are different,

If the program does not work please follow the instructions below.

• Modify [LoadAccelerator.ini] as follows

ShowState = false changed to ShowState = true

ShowFPS = false changed to ShowFPS = true

-This ensures that both FPS and STATE status values ​​are displayed in the lower right corner of the screen

• Start the game and check the STATE value on the loading screen
• Modify [LoadAccelerator.ini] again. Modify the TargetState value so that it is consistent with the STATE value in the second step of STATE.

If using ENB

• Rename [d3d11.dll] (for example [la_d3d11.dll]), and then copy the renamed DLL into it.
• Modify [enblocal.ini] to the following

EnableProxyLibrary = false changed to true

InitProxyFunctions = false changed to true

ProxyLibrary = [DLL you renamed (such as la_d3d11.dll)]

Then

EnableFPSLimit=true changed to false

• Even if ENB's FPSLimit is turned on, the loading time can be reduced, but it is not so obvious.