World Gen Accelerator
Optimizes world location generation with a biome zone cache. Updated for Valheim 1.0.
截圖 共 1 張
模組介紹 作者原文
World Gen Accelerator
Optimizes location placement during world generation by caching zones by biome.
Valheim 1.0
Version 1.0.1 supports the updated zone and location APIs and preserves the new
alternate-biome placement restrictions. Fresh-world generation was tested on
Valheim 1.0.7. Performance relative to vanilla has not been measured on this version.
Features
- Selects candidate zones from a biome cache during location placement.
- Can be removed after world generation finishes.
- Includes optional Expand World Size integration. This integration has not been
tested with Valheim 1.0.
- Sends an anonymous analytics ping at startup. Set Enabled = false in the
[Analytics] configuration section to disable it.
Configuration
Configuration file: BepInEx/config/warpalicious.worldGenAccelerator.cfg.
- [General] EnableOptimization: set to false to use vanilla location generation.
- [General] EnableTimingLogs: controls location-generation timing logs.
Optimized worlds have different location layouts from vanilla worlds with the
same seed. Some location types may not reach their requested placement count.
Support and source
- Discord
- Source code
- Support development on Ko-fi
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時，主機與所有用戶端需要安裝一致的模組。
下面這些內容需要先安裝，否則該模組不會生效：