Warmth
Extends the vanilla Fire/warmth buff to standing torches, wall torches, dvergr lanterns, and the surtling trophy.
模組介紹 作者原文
Warmth
Extends Valheim's vanilla Fire (warmth) buff to a handful of smaller light sources that don't grant it by default. (Standing torches, wall torches, the surtling trophy, and dvergr lights.)
What it does
On world load, it clones the vanilla Campfire's own "Heat" EffectArea component onto each of the listed items. The added heat areas use half (0.5x) the radius of a real campfire's, since these
are smaller, weaker light sources.
Requirements
- BepInEx (Valheim mod loader)
Installation
- Extract to BepInEx/plugins/Warmth in your Valheim
install (or install via a mod manager pointed at this package).
- Launch the game. No configuration needed.
Notes
- This is a host-side/world-load effect — it patches prefab data at startup, so every
player in a multiplayer session needs the mod installed for consistent behavior.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時，主機與所有用戶端需要安裝一致的模組。
下面這些內容需要先安裝，否則該模組不會生效：