PressurePlate
A pressure plate for opening and closing doors
截圖 共 2 張
模組介紹 作者原文
Pressure-Plate
About
Adds multiple variation of pressure plates which open and close doors.
- Wooden pressure plate: 3 wood, 1 surtling core with the hammer. Requires a workbench in range
- Stone pressure plate: 3 stone, 1 surtling core with the hammer. Requires a workbench in range
- Crystal pressure plate, 1 crystal, 1 surtling core with the hammer. Requires a workbench in range
- Black marble pressure plate, 2 black marble, 1 surtling core with the hammer. Requires a workbench in range
Ingame settings
Plate settings
Press 'E' when hovering over a plate to open its setting:
- Trigger Radius: if a player is inside this range, the plate is pressed
- Door Radius: all doors inside this radius are opened/closed
- Activation Time: duration in which the plate is pressed
- Trigger Delay: duration it takes before the plate is pressed
- Invert Doors: inverts open/closed state
- Toggle Mode: the plate stays active after the first press and needs to be pressed again to deactivate
- Ignore wards: allows other players to open doors even they have no access
- Only open if not permitted: The plate only interacts with players that don't have permission inside the ward area. Requires 'Ignore wards' to be active
- Allow creatures to trigger: monster and creatures can also press the plate. Requires 'Ignore wards' to be active
- Tame interaction: decides what certain tame status is needed in order to interact with the plate. Requires both 'Ignore wards' and 'Allow creatures to trigger' to be active
Global settings
Config file at BepInEx/config/com.maxsch.valheim.pressure_plate.cfg
- Plate Volume: set the volume level of all plates. Can be changed while ingame
Manual Installation
- Install BepInEx and Jötunn, the Valheim Library
- Extract the content of Pressure-Plate into the BepInEx/plugins folder.
The mod can be installed at a server to enforce the installation on all clients.
Development
See contributing.
Changelog
See changelog.
Links::
Github:
Discord: Margmas#9562
Credits
- Sound effects:
安裝與使用 安裝:BepInEx 外掛
- 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
- 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時,主機與所有用戶端需要安裝一致的模組。
前置依賴
下面這些內容需要先安裝,否則該模組不會生效:
denikson-BepInExPack_ValheimValheimModding-Jotunn