PocketWorkbench
A 1-wood portable toolbox that works like a workbench for building.No crafting/repairing. No safe zone.
模組介紹 作者原文
PocketWorkbench
A small portable toolbox you can place anywhere for 1 wood. It gives you the same building area as a level 1 workbench, without leaving workbenches scattered around the map.
What it does
- Building: Build, repair and deconstruct workbench-tier pieces, and raise ground with the hoe
- Cost: 1 wood, no workbench needed to place it
- Build area: Same radius as a level 1 workbench
- Footprint: Smaller than a workbench to you don't have the hassel of placing it down in tight spots.
What it doesn't do: no crafting, no repairing gear, and no "player base" safe zone, so enemies still spawn around it.
Good for
- Building roads, signs, ramps and torches out in the field
- Quick camps away from home
- Reaching the edges of a big base without placing extra workbenches everywhere
Find it in the Hammer menu, right after the workbench.
Requirements
- BepInExPack for Valheim
- Jotunn
Mod managers install both automatically.
Manual installation
- Install BepInExPack for Valheim and Jotunn.
- Put Toolbox.dll in Valheim/BepInEx/plugins.
Multiplayer
Everyone on the server, and the server itself, needs the mod installed.
Possible Future Plans
- Forge or stone table version.
- Basic tool repairs.
Changelog
1.0.0: Initial release
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時，主機與所有用戶端需要安裝一致的模組。
下面這些內容需要先安裝，否則該模組不會生效：