MarkerCommand

版本 v1.2.1·更新於 2026-10-10

Console command for adding map markers at coordinates or your current position, with optional names and icons.

模組介紹 作者原文

MarkerCommand

ai usage disclaimer

with the exception of this readme, everything in this repo is ai-generated.

description

this mod adds a console command that allows you to place a marker on the map at specific coordinates

non-goals

this project will not make any attempt to support icons not included in the "supported icons" list below.

usage

you can enter these into the developer console or chat. if you are entering them in chat you must prefix them with, e.g. /marker me.

all parameters other than position (me or ) are optional. if an icon type is not specified, the default dot (icon3) is used.

place marker at current position

marker me [name] [icon]

place marker at coordinates

marker [name] [icon]

examples

mark bone crypt as you run past

marker me "spooky skellington cave" rune

plot a course through the sea

marker -2819 -1642 "noboat canal" death

combining with keybinds

bind marker me "some mushrooms to pick after i lose this troll" hammer

press `` to drop a marker without stopping to type

supported icons

standard icons

icons that you can place on the map normally via double clicking

  • fire (also accepts icon0): campfire, the first icon
  • house (icon1): the second
  • hammer (icon2): aka anchor, the third
  • dot (icon3): the fourth
  • rune (icon4): i dont know what the hell this thing is, but it's the bottom one

special icons

icons that are not normally placeable by the player. i have not tested these with the cartography table, so godspeed.

  • death
  • bed
  • shout
  • boss
  • player
  • randomevent
  • ping
  • eventarea
  • memorial
  • hildir1, hildir2, hildir3

安裝與使用 安裝:BepInEx 外掛

  1. 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
  2. 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
  3. 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
  4. 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。

帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時,主機與所有用戶端需要安裝一致的模組。

前置依賴

下面這些內容需要先安裝,否則該模組不會生效:

denikson-BepInExPack_Valheim

檔案與校驗

檔案名稱
MarkerCommand-1.2.1.zip
檔案大小
68.4 KiB