KeepFoodOnDeath

版本 v1.0.0·更新於 2026-10-02

Keep your active foods and remaining timers through death. Respawn with their health, stamina, and eitr benefits intact.

模組介紹 作者原文

Keep Food On Death

Your next corpse run starts with a full stomach.

Keep Food On Death preserves the foods you've eaten when you die in Valheim, including their remaining duration. If a meal has 10 minutes left when you fall, it still has 10 minutes left when you return. Timers pause while you're dead and resume after respawn.

You'll respawn with health, stamina, and eitr filled to the maximum your remaining foods provide, ready to get back into the fight.

Features

  • Keep your active meals: Foods you've already eaten survive death.
  • Keep the remaining time: Food durations carry over without resetting to a fresh meal.
  • Pause timers while dead: Waiting to respawn doesn't use up your food.
  • Restore food benefits: Respawn with full health, stamina, and eitr at your current food-based maximums.
  • Keep normal food decay: Bonuses decrease normally as food timers run down, and meals still expire.

Tombstones, inventory drops, and skill loss continue to follow your existing game rules.

Installation

Requires BepInEx 5 for Valheim.

  • Close Valheim.
  • Place KeepFoodOnDeath.dll in Valheim/BepInEx/plugins/KeepFoodOnDeath.
  • Launch the game and play.

For multiplayer, install the mod on each player's client that should retain food. No dedicated-server installation is required.

Compatibility

Other mods that change food removal or replace death and respawn behavior may conflict. Compatibility with those combinations has not been verified.

Release status

Version 1.0.0 has been compiled against the developer's local Valheim installation and passed 18 isolated logic checks. In-game death and respawn testing is still pending.

Uninstall

Close Valheim and remove the KeepFoodOnDeath folder from BepInEx/plugins. Future deaths will use the normal food-loss behavior.

安裝與使用 安裝:BepInEx 外掛

  1. 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
  2. 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
  3. 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
  4. 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。

帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時,主機與所有用戶端需要安裝一致的模組。

前置依賴

下面這些內容需要先安裝,否則該模組不會生效:

denikson-BepInExPack_Valheim

檔案與校驗

檔案名稱
KeepFoodOnDeath-1.0.0.zip
檔案大小
202.2 KiB