EpicLootCraftFromContainers
Integrates EpicLoot's Enchanting Table with CraftFromContainers, using the same nearby containers supported by CraftFromContainers.
模組介紹 作者原文
EpicLootCraftFromContainers
A small compatibility bridge between EpicLoot and CraftFromContainers.
EpicLoot's Enchanting Table can count and consume materials from the same nearby containers that CraftFromContainers already supports.
Features
- Adds CraftFromContainers storage support to the EpicLoot Enchanting Table.
- Uses CraftFromContainers for nearby-container discovery instead of maintaining a separate container list.
- Therefore works with any container that CraftFromContainers can expose through the normal container inventory path.
- Tested locally with vanilla containers and RossItemDrawers.
- Respects CraftFromContainers' enabled/prevent-key state and LeaveOne behavior.
Tested with
- Valheim 1.0.14
- EpicLoot 0.14.8
- CraftFromContainers plugin 4.0.3 (UnderHeiz package)
- RossItemDrawers 1.0.10
Installation
Install through r2modman, or place EpicLootCraftFromContainers.dll in your BepInEx/plugins folder.
Both EpicLoot and CraftFromContainers are required.
How it works
The bridge registers CraftFromContainers as an EpicLoot inventory provider. Container discovery is delegated to CraftFromContainers, so this mod does not implement its own list of supported chest/container types.
If CraftFromContainers can use a nearby container, EpicLoot should be able to use its materials through this bridge as well.
Notes
- Local/single-player functionality has been tested.
- Simultaneous multiplayer access to the same container has not yet been extensively tested.
- If you find a container that works with CraftFromContainers but not with this bridge, please report it with a BepInEx log.
AI disclosure
A significant portion of the initial compatibility bridge code and package documentation was created with AI assistance.
安裝與使用 安裝:BepInEx 外掛
- 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
- 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時,主機與所有用戶端需要安裝一致的模組。
下面這些內容需要先安裝,否則該模組不會生效: