DangerousEnemies BIG Edition
Makes Valheim combat unpredictable.
模組介紹 作者原文
Dangerous Enemies BIG Edition
This mod introduces some unpredictability to enemy combat behavior. It does this by randomizing attack intervals and animation speeds.
Main Features:
Randomizes enemy combat behavior by:
- Changing the interval of specific enemy melee attacks (i.e. Troll's Vertical Log/Trunk Swing) each time this attack is done to a new value between a max. and min. number you set.
- Changing the animation speed of a section (initial part) of certain enemy attack animations by multiplying it by a value between a max. and min. number you set. This value is randomly chosen every new attack.
You control this through the following variables:
- Max. animation speed multiplier = the max. possible factor by which the animation speed is multiplied (ceiling)
- Min. animation speed multiplier = the min. possible factor by which the animation speed is multiplied (floor)
- Base duration of animation speed multiplier = the time during which the speed multiplier is active (this value changes depending on the value the speed multiplier is given during every attack).
- Reducing the stagger factor of affected enemies to 0.15 (standard is 0.3) for combat balance, this will cause them to stagger faster
- Increases the time for the (invisible) stagger bar of affected enemies to deplete, this will give you more time to apply enough damage to stagger the enemy
Additional Features:
- Troll projectile (rock throw) is now far more dangerous
- Area covered by Abomination AOE attack is enlarged slightly
- Serpents attack more often
- Changes to each individual enemy can be turned on or off
- Should be server-friendly, each member will need the mod installed (attack intervals are controlled by server-host, animations are not, I HAVE NOT TESTED THIS)
- All of the above is configurable
Tips:
- If you want to play around with the configurable values I highly recommend you check these in a test world by spawning in the enemy in question. Then trial-and-error your way to a configuration that suits you.
- I have tested each enemy on a solo world. The preset configuration is well balanced to my mind.
- I have found it usually requires a game restart to have the new configuration take effect.
Installation:
Install using a mod manager, or place the.dll file in the...BepInEx\\Plugins folder of your game
Changelog:
1.0.0 Initial release
安裝與使用 安裝:BepInEx 外掛
- 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
- 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時,主機與所有用戶端需要安裝一致的模組。
前置依賴
下面這些內容需要先安裝,否則該模組不會生效:
denikson-BepInExPack_ValheimValheimModding-Jotunn