ChaseMods JumpAltersFallingDamage
Jump skill alters the falling damage calculation.
模組介紹 作者原文
# Jump Alters Falling Damage
Jump skill alters the falling damage calculation by increasing the safe fall height and adding falling damage reduction.
Installation
- Install BepInEx.
- Extract the mod into _Valheim_\BepInEx\plugins folder.
- Start the game normally.
- (optional) Configure the damage scaling to your liking using _Valheim_\BepInEx\config\ChaseMods.JumpAltersFallingDamage.cfg.
Configuration
MinUnskilledDamagingHeight
The fall height that starts to damage you at Jump skill level 0. Falling from a height lower than this value causes no damage.
Game default: 4
MinSkilledDamagingHeight
The fall height that starts to damage you at Jump skill level 100. Falling from a height lower than this value causes no damage.
Game default: 4
MaxDamagingHeight
The fall height that causes you maximum fall damage. Falling from a greater height causes no additional damage.
Game default: 16
MaxFallDamageReduction
Fall damage reduction factor at Jump skill level 100.
Game default: 1 (no reduction)
MaxFallDamage
Maximum allowed fall damage (before reduction).
Game default: 100
Changelog
1.1.1
- Calculation fixes (may result in a small increase in fall damage)
- Configuration sanity checks
1.1.0
- MaxFallDamage
- Configuration option descriptions
- Changelog
1.0.1
- Fixed manifest.
1.0.0
- Initial version
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時，主機與所有用戶端需要安裝一致的模組。