BoarBreedingUnlimited
Removes or raises the population cap so tame animals keep breeding. Optional configurable cap.
模組介紹 作者原文
BoarBreedingUnlimited
Removes the built-in population cap that stops tame animals from breeding once a few of them are nearby.
What it does
Vanilla Valheim caps breeding at 4 nearby animals of the same species. Fill a pen with 4 boars and they simply stop reproducing. This mod bypasses that check, so a well-fed and happy pen keeps producing offspring indefinitely.
Applies to every creature that uses the Procreation component: boars, wolves, lox, and chickens.
Configuration
The config file is BepInEx/config/com.honeymanmods.boarbreedingunlimited.cfg. It is created the first time you launch the game with the mod installed. You can edit it Mod Manager / r2modman (Config editor), or in-game with ConfigurationManager (F1).
| Setting | Default | Description |
|---|---|---|
| LimitPopulation | false | false = unlimited breeding. true = use the cap below. |
| MaxCreatures | 20 | Cap per species in the local area (range 3-100). Only used when LimitPopulation = true. |
Tips for MaxCreatures:
- Vanilla is about 4.
- The parents count toward the cap, so 3 is the lowest value that still allows breeding.
- 10-30 is a good range for a pen.
- Above ~50 animals in one spot, most PCs start to lag.
- The cap counts each species separately and only looks at nearby animals, so separate pens are capped separately.
Install
Recommended: install Mod Manager or r2modman.
Manual: drop BoarBreedingUnlimited.dll into /BepInEx/plugins.
Server / multiplayer
- Singleplayer / player-hosted: install on the host.
- Dedicated server: install on the server. Client-side install is optional (won't hurt, but the server owns breeding logic).
Warning
Uncapped breeding means a pen left unattended will grow without bound. Large numbers of active creatures hurt performance. Cull manually as needed.
Changelog
1.1.0
- Added config: LimitPopulation (on/off) and MaxCreatures (3-100) for an optional custom breeding cap. Default stays unlimited.
1.0.0
- Initial release.
安裝與使用 安裝:BepInEx 外掛
- 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
- 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時,主機與所有用戶端需要安裝一致的模組。
下面這些內容需要先安裝,否則該模組不會生效: