AshlandsWaterFix
Fixes retained Ashlands ocean heat and restores the heat-distortion overlay with a two-second cooldown.
模組介紹 作者原文
Ashlands Water Fix
A small client-side BepInEx plugin for Valheim 1.0.12.
What it fixes
Valheim 1.0 introduced a separate internal heat value for the Ashlands ocean,
but that value is never reduced after leaving the water. Once fully heated, a
player can therefore take immediate full damage when entering water again.
The same change disconnected Ashlands ocean heat from the existing camera heat
effect, removing the gradual visual warning that existed before release.
This mod:
- Cools a full Ashlands ocean heat charge to zero at a constant rate over two
seconds after leaving dangerous water.
- Preserves partial heat if the player re-enters before those two seconds pass.
- Also cools retained heat in safe, non-Ashlands water.
- Restores the heat-distortion overlay and makes it fade in and out with the
actual ocean heat level.
The mod does not change heat buildup, damage, equipment heat resistance, or
lava behavior.
Installation
- Install BepInExPack for Valheim 5.4.2333 or later.
- Copy AshlandsWaterFix.dll into a folder under BepInEx/plugins.
Only the client needs the mod. Installing it on a dedicated server is not
required.
Building
The project targets.NET Framework 4.6.2. Build the release package with:
dotnet build AshlandsWaterFix/AshlandsWaterFix.csproj -c Release
The -ready archive is written to
dist/AshlandsWaterFix-1.0.0.zip.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時，主機與所有用戶端需要安裝一致的模組。
下面這些內容需要先安裝，否則該模組不會生效：