VelosityGivesPower
Damage scales with relative speed. Melee uses sqrt curve; projectiles use squared curve. Mult=1 at baseline speed.
模組介紹 作者原文
VelosityGivesPower
Damage scales with relative speed between the attacker and the hit target.
Formula
ratio = relativeSpeed / baselineSpeed
| Type | Multiplier | Baseline |
| --- | --- | --- |
| Melee | √ratio | Configurable (default 10 m/s) |
| Projectiles | ratio² | Launch speed of the projectile |
When relative speed equals baseline, multiplier = 1.
Relative speed = |velocity_attacker − velocity_hit_part|.
Install
- Install BepInExPack_TABS
- Install this mod with a mod manager, or drop the dll into BepInEx/plugins/
- Launch the game
Config
After first launch: BepInEx/config/local.velocitydamage.cfg
| Key | Default | Description |
| --- | --- | --- |
| Enabled | true | Enable the mod |
| AffectMelee | true | Scale melee hits |
| AffectProjectiles | true | Scale projectile hits |
| MeleeBaselineSpeed | 10 | Relative speed (m/s) where melee mult = 1 |
| ProjectileFallbackBaseline | 40 | Used if launch speed was not recorded |
| MinMultiplier | 0.15 | Floor clamp |
| MaxMultiplier | 3 | Ceiling clamp |
| DebugLog | false | Log each calculation |
Notes
- Projectile baseline is captured when MoveTransform.InitializeVelocity runs (launch speed).
- Multipliers are applied only for the hit frame; base weapon/projectile damage is restored afterward.
- Works alongside other damage mods (e.g. GaussianProcess / UnitRng) when both are installed.
Changelog
1.0.0
- Initial release
- Melee: sqrt curve
- Projectiles: squared curve
安裝與使用 安裝：按包內說明操作
- 解壓本站下載的壓縮包，先讀包內的 readme / 說明檔案。
- 多數模組依賴遊戲的模組載入器：常見做法是用社群模組管理器（如 r2modman）選中本遊戲安裝，由管理器自動處理載入器與依賴。
- 手動安裝時，把模組檔案放進遊戲目錄下對應的 Mod / plugins 資料夾。
- 啟動遊戲確認載入成功；帶「前置依賴」的模組需要把依賴一併安裝。
不同模組的安裝位置差異較大，包內說明是最可靠的依據。
下面這些內容需要先安裝，否則該模組不會生效：