TeleporterShowRedux
Shows the teleporter if you have 'discovered' it, pinged it, or all the time if you change the config.
模組介紹 作者原文
Teleporter Show Redux
This mod gives the ability to mark the teleporter with a few different options:
- The player is close enough to the teleporter (This distance can be adjusted in BepInEx/config/com.Pipman3000.TeleShowRedux)
- The player has pinged the teleporter (this can be turned off in BepInEx/config/com.Pipman3000.TeleShowRedux)
- All the time (this can be turned on in BepInEx/config/com.Pipman3000.TeleShowRedux )
Change Log
--1.0.4--
Everyone doesn't have to have this mod installed in a multiplayer lobby anymore.
--1.0.3--
Fixed a NullReferenceException spam that would happen in certain scenarios in multiplayer.
--1.0.2--
Changed how the 'Always Show' option works. Before, if anyone in a multiplayer lobby had Always Show on, it would immediately reveal the teleporter to all other players. This doesn't make much sense because in practice, this means it will override everyone else's settings.
Instead, players who have the Always Show option enabled in a multiplayer lobby will still be shown the teleporter's location immediately, but the teleporter will only be revealed to other players when that player would have revealed it normally (through ping or discovery).
If both ping and discovery are disabled in the config, then that player won't be able to reveal the location to anyone else.
--1.0.1--
Fixed a typo in the README.
--1.0.0--
Reworked the original TeleShow mod (added some settings and some small optimizations), also fixed the NullReferenceException spam when you died in multiplayer. Additionally, Teleporter indicator status is now sync'ed across all multiplayer clients.
安裝與使用 安裝:BepInEx 外掛
- 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
- 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝,否則該模組不會生效: