CorpseBloomReborn

版本 v1.4.0·更新於 2025-12-12

CorpseBloom Adjustment, Highly Configurable!

截圖 共 1 張

模組介紹 作者原文

CorpseBloomReborn

Corpsebloom now grants a percentage of maximum health as reserve.

  • Healing is stored into reserve and heals you over time.

Prevent healing multipliers from affecting healing twice while using Corpsebloom.

  • Rejuvenation Rack double healing can be re-enabled with config.

Configure when healing goes into reserve. (these are disabled by default)

  • HealBeforeReserve prioritizes healing into health before going into reserve.
  • HealWhenReserveFull will cause any extra healing past full reserve to go back into health.

Reserve usage is modified by different situations.

  • Reserve has a minimum and maximum usage rate.
  • Reserve is not used while under the effect of Malachite HealingDisabled.
  • Reserve is used at minimum rate when fully healed.
  • Aegis causes usage rate to approach maximum as barrier fraction approaches 0.
  • Reserve usage rate being divided by stack count can be re-enabled with config.

Current reserve is shown as a purple bar on the HealthBar of the HUD and AllyCards.

Installation:

Requires Bepinex and HookGenPatcher.

Use r2modman or place inside of Risk of Rain 2/Bepinex/Plugins/

Changelog:

v1.4.0 - Updated for AC.

Credits:

paddywan for creating CorpseBloomPlusPlus which I referenced to start this project.

安裝與使用 安裝:BepInEx 外掛

  1. 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
  2. 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
  3. 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
  4. 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。

帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。

前置依賴

下面這些內容需要先安裝,否則該模組不會生效:

bbepis-BepInExPackRiskofThunder-HookGenPatcher

檔案與校驗

檔案名稱
CorpseBloomReborn-1.4.0.zip
檔案大小
76.3 KiB