Fatigue
Climbing fatigue with campfire regen, bleed synergy, custom expedition menu integration. Part of the TambiStudios Afflictions Pack.
模組介紹 作者原文
Fatigue
Climbing in PEAK is no longer free. Long, continuous climbs now drain a hidden energy budget, and once it runs out, drowsiness sets in on your stamina bar.
How it works
You start every climb with an energy budget of 6 points. Different activities drain it at different rates per second:
- Climbing up a wall: 1.0
- Climbing sideways: 1.5 (most expensive — awkward movement)
- Climbing down: 0.5
- Just hanging on a wall: 0.1
- Moving on a rope: 0.3
- Hanging on a rope: 0.1
- Moving on a vine: 0.9
- Hanging on a vine: 0.1
Climb-jump (the sprint-burst move): instant -1.5 energy per burst. Use them wisely.
When your energy hits zero, Drowsy starts accumulating on your stamina bar at 0.025 per second. The longer you stay off the ground, the deeper the drowsiness gets.
How to recover
Touch the ground. The instant your feet are on solid ground, your energy budget resets to full. Drowsy fades naturally over time as the game already handles.
So the loop is: climb hard, find a ledge, rest a moment, climb again. Don't try to scale a whole face in one go — you'll fall asleep at the top.
Multiplayer
Fully synced — the game handles Drowsy syncing on its own, so everyone sees everyone's drowsiness on the bar.
Difficulty scaling
Energy costs scale with Ascents difficulty:
- Easy / no hazards: x1 (or disabled if all hazards off)
- Normal: x1.5
- Hard: x2
Energy bar
A custom energy bar appears above the stamina bar showing your current energy budget at a glance. It fills from the left and pulses when draining.
Debug
Set EnableDebugKeys = true in the config to enable an on-screen HUD that shows your current energy, cost-per-second, and current state (climb-up, climb-side, climb-hang, etc.).
Compatibility
Compatible with most other mods — only patches Character.Awake and reads vanilla fields.
Credits
Made by Tambi Studios. Original idea by Dani Danisha.
安裝與使用 安裝:BepInEx 外掛
- 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
- 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝,否則該模組不會生效: