InteriorHazardsPlus
For those of you that like the challenge and now compatible with NEW hazards from mods like CodeRebirth,Surfaced,TestAccountVariety and LethalThings
模組介紹 作者原文
InteriorHazardsPlus
- Fixed hard dependency issues will work with CodeRebirth, LethalThings, TestAccountVariety or Surfaced individually so they are no longer required to use this mod. It will detect what hazards are available from the installed/enabled mods and add them to the config.
- This is a Configuration mod to adjust how many interior hazards spawn on the map.
- The config will add hazards to maps that don't normally have that hazard.
- This mod works for Original Moons and Modded Moons/Interiors.
- I added an option to randomize hazards in the config which is set by default. Each time you leave the moon it will reshuffle the hazards and spawn rates in config and set them to something different for your next round.
- The Config automatically recognizes when a new moon has been loaded and applies my default set configs for it. If you prefer to change the configs just BEWARE maxing out the configs will make the game basically unplayable. You can set everything to max but I wouldn't advise it.
- Smaller interiors may have heavier hazard grouping.
- I added a patch to stop hazards from damaging or killing the Enemy, now configurable under "Hazards Kill Enemy" in General tab.
- "Reset All Hazards" option in config to disable all.
- "Enable All Hazards" option in config to enable all.
- If using LethalConfig you can use these config options to change from “Customize Hazards” to “Random Hazards” in between rounds just make sure to hit Apply.
- ATTN:I added a patch to reduce damage from BearTraps, please ensure you enable BearTraps in CodeRebirth config to spawn inside or they will not work.
Discord
- Lethal Company OTH
Enjoy
安裝與使用 安裝:BepInEx 外掛
- 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
- 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
前置依賴
下面這些內容需要先安裝,否則該模組不會生效:
BepInEx-BepInExPack