CruiserJumpsHelper
Save named cruiser jump spots per moon with wheel-accurate markers, a steering hint, snap-to-spot, landing trajectory preview, and one-click preset sharing.
模組介紹 作者原文
Cruiser Jump's Helper
Never lose your favorite Company Cruiser jump spot again.
Cruiser Jump's Helper lets you save named "parking spot" markers for
the Cruiser on any moon, sized exactly to the cruiser's real wheelbase, so
you can line up the same jump every time.
Features
- Multiple named presets per moon — save as many jump spots as you
want, rename or delete them anytime.
- Real-size outline markers — each marker is sized from the cruiser's
actual wheel positions, not a generic square, and shows a small arrow
for the target facing direction.
- All presets visible at once, with the selected one highlighted and
markers turning red once the cruiser is (almost) perfectly aligned.
- Steering hint — an on-screen readout of how many degrees to turn to
match the target heading.
- Snap to spot — instantly snap into perfect alignment with one key
press, or enable a gentle auto-snap magnet that pulls you in once
you're close and nearly stopped.
- Landing trajectory preview — while airborne after a jump, a line
shows roughly where the cruiser is going to land.
- Share presets with friends — copy a preset to your clipboard and
send it to a friend; they paste it in and get the exact same spot.
Controls (configurable in the BepInEx config file)
| Key | Action |
|---|---|
| F6 | Update the selected preset with the cruiser's current position |
| F9 | Create a new preset |
| F10 | Rename the selected preset |
| F11 | Delete the selected preset |
| [ / ] | Cycle to the previous/next preset on this moon |
| Home | Instantly snap to the selected preset (Warn: This is instant teleport cruiser to point!!!) |
| Page Up | Copy the selected preset to the clipboard |
| Page Down | Import a preset from the clipboard |
All keybinds, tolerances, and toggles (auto-snap, trajectory preview,
ship/preset connector lines, steering hint) can be changed in the config
file after the first run, or via a mod like ConfigurationManager.
Notes
- Client-side visuals; presets are stored locally per install.
- Feedback and bug reports welcome — this is an early release.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝，否則該模組不會生效：