SpeedrunGym

版本 v0.4.2·更新於 2026-10-01

Utilities for practicing speedruns

截圖 共 2 張

模組介紹 作者原文

SpeedrunGym

Contains utilities for speedrun practice. Feature ideas welcome.

Can be configured using BepInEx configuration, e.g. at runtime

using ConfigurationManager.

RNG Normalization

Craw pogo

Normalize how early the first craw dives.

  • Early - dive as soon as possible
  • Late1 - dive after one more flap cycle
  • Late2 - dive after two more flap cycles

Pogo Endlag Detection

When enabled, will display why a pogo endlag cancel failed, or how close it was to being optimal.

Possible popup messages:

  • repress +Xms - success, re-pressed direction X ms after the neutral landing.
  • jump +Xms - jumped X ms after the earliest possible jump, shown on a second line.
  • dir repress Xms early - failed, you pressed a direction X ms too early.
  • neutral Xms late - you went neutral X ms too late.
  • no neutral - you never went neutral.

Jump Timing

Two independently toggleable air-jump readouts, shown as popups next to Hornet.

  • Sprintjump Release - out of a sprintjump, shows the vertical velocity at the moment you released jump. yvel ≈ 0

means you let go right at the peak, - = still gaining height, + = falling.

  • Repress - if you repress jump in order to get float, show how long the repress took

Training Dummy

Spawns a neutralized grand reed next to Hornet as a training dummy.

  • Contact damage - Off, EffectOnly (regular hit, but no HP lost) or Damage.
  • Take knockback - whether attacks knock the dummy back.

安裝與使用 安裝:BepInEx 外掛

  1. 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
  2. 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
  3. 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
  4. 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。

帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。

前置依賴

下面這些內容需要先安裝,否則該模組不會生效:

BepInEx-BepInExPack_Silksongsilksong_modding-AssetHelper

檔案與校驗

檔案名稱
SpeedrunGym-0.4.2.zip
檔案大小
70.6 KiB