PKM 2
Ya da da da da da da
模組介紹 作者原文
PKM 2.0
The gun come with half disintegratable belts, heat effect, and several togglable(?) parts: Click the barrel, stock, bottom of the pistol grip, front of the beltbox mount to chage model.
When click the left of the receiver, a foldable dove tail will appear, and be aware that you can grab the topcover only when dove tail flipped open.
Click above the handguard trigger to toggle bullpup mode.
How to reload?
1.Using beltbox:
First grab your belt box and put it near the box holder frame, once it's attached to the gun, drag the beltbox and rotate 45 degrees then pull out the belt to reload like a normal MG.
After firing all the bullets, open the topcover, grab the lifter and lift it to release the empty belt segment, then grab the belt box and rotate -45 degrees and it will eject.
2.Using APinc Belt:
Just open the topcover and put the belt in, when belt is empty it will automatically eject.
3.Using AmmoBackPack
This bulky backpack holds 2000rnd of tracer. Like the APinc Belt, put the piece direct onto the gun, and put the backpack on your backpackslot, but be aware of emeny fire
----If the backpack received enough damage it will break and stop working! Also, if you put the PKM too far away from the ammobackpack, the belt will be ripped off from the receiver.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝，否則該模組不會生效：