AllFloorsSafety

版本 v1.0.2·更新於 2024-04-26

All Floors Safety is an Enter The Gungeon mod designed to mitigate common run-ending circumstances when attempting an All Floors run

模組介紹 作者原文

All Floors Safety is an Enter The Gungeon mod designed to mitigate common run-ending circumstances when attempting an All Floors run. The concept for this mod originated from DanTheVP and members of his Discord.

Features

  • Water Drums in Keep of the Lead Lord (Floor 1) no longer break unless rolling into the fireplace.
  • Old Crest now spawns on the Round Table in the Shop in Gungeon Proper (Floor 2).
  • Has a cost of zero and can only be picked up if you currently do not already have an Old Crest.
  • Gnawed Key in the Shop in Gungeon Proper (Floor 2) can always be purchased, regardless if you can afford it or not.
  • If you cannot afford it, you will have negative casings.
  • There will always be two Blanks spawned on the Round Table in the Shop in Black Powder Mine (Floor 3).
  • All characters spawn with a new passive item, the Safety Round.
  • The Safety Round acts like a Master Round, but does not give an additional heart.
  • Like Master Rounds, if in your possession when entering The Hollow (Floor 4) you will always spawn the Sell Creep.
  • Like Master Rounds, you can sell the Safety Round to The Hollow (Floor 4) Sell Creep as part of the requirement to reach the R&G Dept.

Compatibility Disclaimer

This mod may not be compatible with certain mods. Since this mod alters vanilla functionality there are several places where a non-invasive change was not possible. If you're interested in knowing where these invasive changes were made you can find them within the Hooks folder of the mod source code.

Source Code:

ETG All Floors Safety Mod

This mod utilizes Kyle The Scientist's ItemAPI.

Special Thanks

Huge thanks to SpecialAPI for converting the mod to work!

The Gungeon Discord

N0tAB0t

Nevernamed

An3s079

Apache Thunder

安裝與使用 安裝:BepInEx 外掛

  1. 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
  2. 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
  3. 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
  4. 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。

帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。

檔案與校驗

檔案名稱
AllFloorsSafety-1.0.2.zip
檔案大小
14.2 MiB