TweakMecha

版本 v1.0.0·更新於 2023-12-26

This mod allows you to weak your mecha. Currently warp and cruise speeds. The speed is configurable in AUs or LYs. More to come later.

模組介紹 作者原文

TweakMecha

This mod allows you to tweak your mecha.

You can change warp speed, and cruise speed at the moment. More to come later.

The speed is configurable in AUs or LYs.

Note

This mod doesn't modify any entities and should not affect any save data.

Any issues with the mod after a game update can be bypassed by disabling the mod until it is updated.

Usage

Install the mod and start up the game for the config file to be generated.

If you desire to change the default configuration (Max warp speed 1 LY), you'll need to restart the game.

Configuration

Disclaimer

Setting speeds > 0.5 LYs may prove difficult when trying to "crash land" into a planet.

It is recommended to exit warp when near a planet if you choose to select a speed that high.

WarpSpeed

Speed at which you'd like the maximum warp to be set. This can be in LYs or AUs depending on the configuration of SpeedType

  • Type: double
  • Default value: 1.0

WarpSpeedType

Speed measurement to use when configuring the speed. This can be AU or LY. Note LY = 60 * AU.

  • Type: ESpeed [AU/LY]
  • Default value: LY

CruiseSpeed

Speed at which you'd like the maximum warp to be set. This can be in LYs or AUs depending on the configuration of SpeedType

  • Type: double
  • Default value: 1.0

CruiseSpeedType

Speed measurement to use when configuring the speed. This can be AU or LY. Note LY = 60 * AU.

  • Type: ESpeed [AU/LY]
  • Default value: LY

Changelog

v1.0.0

  • Initial Release

Thanks

Thanks to modding community in general.

Credit to for the initial code, and his shoutout to the blow folks

"Shoutout to sp00ktober and Pasukaru as I referenced some code and conventions from them. This helped me build this mod cause I'm a noob."

安裝與使用 安裝:BepInEx 外掛

  1. 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
  2. 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
  3. 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
  4. 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。

帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。

檔案與校驗

檔案名稱
TweakMecha-1.0.0.zip
檔案大小
136.0 KiB