MegaRayReceiver
Increases the requestable energy of Ray Receivers
截圖 共 2 張
模組介紹 作者原文
MegaRayReceiver
Introduction
Mod for Dyson Sphere Program to make the ray receiver be able to request more power, have more efficiency or always stay connected.
For now, it doesn't trigger the abnormality check, meaning achievements will not be disabled.
Default multiplier value is 10x, see below for configuration.
Configuration
The multiplier can be configured in-game via the power tab of the statistics panel. Changes are applied on-the-fly, so if the value is changed in the panel, this will directly affect all ray receivers in the game.
As of version 1.1.4 the ray receiver's efficiency can also be adjusted. An efficiency of 10 or slider completely to the left, will result in the game's default (researched) efficiency, other values will set the respective efficiency value up to 100%.
There's also a switch to enable the ray receiver to always stay connected, even if there is no line of sight to the dyson sphere. This also works on planets wihout atmosphere.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝，否則該模組不會生效：