DSPMirrorBlueprint
Mirror Dyson Sphere Program blueprints horizontally or vertically while placing them, without changing the saved blueprint.
模組介紹 作者原文
DSP Mirror Blueprint
Mirror a blueprint horizontally or vertically while placing it. Your saved
blueprint is not changed.
Controls
- Press K to mirror across the horizontal axis, exchanging top and bottom.
- Press Shift+K to mirror across the vertical axis, exchanging left and
right.
The placement preview flips immediately and shows the layout that will be
built. Pressing the same shortcut twice restores that axis to its original
layout. The saved blueprint remains unchanged.
Requirements
- Dyson Sphere Program (validated and fully supported on 0.10.35.29057)
- BepInEx 5
Installation
With a -compatible mod manager, install DSP Mirror Blueprint and
launch Dyson Sphere Program with mods enabled. The required BepInEx dependency
is installed automatically.
For manual installation, install BepInEx 5 and copy the package's BepInEx
folder into the Dyson Sphere Program game folder.
Support and source
View the source or report a problem.
DSP Mirror Blueprint is an unofficial community project. Dyson Sphere Program
belongs to its respective owners.
License
DSP Mirror Blueprint is licensed under the Apache License 2.0 included in this
package.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝，否則該模組不會生效：