WiresEnemyHUD
Health bars but good.
模組介紹 作者原文
Wire's Enemy HUD
An improvement to Valheim's enemy HUD that keeps the vanilla look.
exclusive info:
I am REALLY sorry but its not letting me upload the changelog this time! 0.5.2 added improved visibility conditions for the health bars and customizable font size!
Features
- Vanilla-style stagger bars, including the white flash when enemies stagger.
- Optional HP numbers for enemies, bosses, and multiplayer players.
- Current HP, current/max HP, percentage, or no counter.
- Optional thicker enemy/player HP bars, awareness name colors, and uppercase names.
- DPS meters for enemies, bosses, and players, separately: On, On + DPS, or Off. Uses Terraria-style DPS timing based on damage actually taken.
- Independent font sizes for HP/% and DPS.
- Show on damage: damaged enemies show their normal nameplate for one second. Another hit refreshes the timer. This is an additional condition, so normal nameplate visibility still works.
- Keep bars on screen: if a normally visible enemy nameplate leaves the screen, it stays clamped to the viewport edge. Above the screen, it tracks horizontally along the top rather than becoming a separate indicator.
- A brief white outline flash around enemy HP on actual backstab/stagger-critical hits, matching the stagger flash.
- Default, Vanilla+, and Vanilla presets. Vanilla keeps it completely vanilla so you can config it from the ground up, Vanilla+ has some stuff enabled by default and default is my personal preset.
- Multiplayer stagger synchronization.
Disclaimer: the code is AI assisted since I barely know C#. Not fully AI nor human.
<- donations, but not recommended since I didn't fully code it myself
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時，主機與所有用戶端需要安裝一致的模組。