TastyAdrenaline
Grants a small adrenaline gain while Tasty Mead is active.
模組介紹 作者原文
Tasty Adrenaline
Tasty Adrenaline is a small mod that adds configurable adrenaline interactions to Tasty Mead. The default behaviour is to add a tiny adrenaline gain during the duration of the Tasty Mead effect. This is intended to keep adrenaline from decaying at key times, so you can get your trinket to activate, but can be configured for other usecases!
Effect
- Drinking Tasty Mead applies its normal status effect.
- While Tasty Mead is active, gain a configurable amount of adrenaline (default 1) on a 2-second interval.
- The effect lasts 10 seconds and can be configured with a first and final tick override. Both default to 0.
Configuration
In BepInEx/config/com.celwood.tastyadrenaline.cfg you can configure:
- AdrenalinePerTick: the normal amount gained on each regular tick. Defaults to 1, resulting in 6 total adrenaline.
- InitialAdrenalineAmount: amount gained immediately at the start. Defaults to 0, which uses AdrenalinePerTick instead.
- FinalAdrenalineAmount: amount gained on the final tick. Defaults to 0, which uses AdrenalinePerTick instead.
- AdrenalineMultiplier: multiplier applied to other positive adrenaline gains while Tasty Mead is active. This does not include the adrenaline gain from all sources of tasty adrenaline (ticks, initial boost and final boost). Defaults to 1 (ie, disabled).
Installation
Install these dependencies through your preferred Valheim mod manager:
- BepInExPack Valheim
- Jotunn
Place TastyAdrenaline.dll in your Valheim BepInEx/plugins folder, then launch the game.
Issues / Support
Feel free to let me know if you experience any bugs, or have ideas for features or balance suggestions!
安裝與使用 安裝:BepInEx 外掛
- 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
- 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時,主機與所有用戶端需要安裝一致的模組。
下面這些內容需要先安裝,否則該模組不會生效: