Sparring

版本 v0.2.1·更新於 2026-09-21

Duel another player without either of you dying. Yield instead of falling, then both of you get back up.

截圖 共 1 張

模組介紹 作者原文

Sparring

Duel another player without either of you dying.

Look at another player and type /duel in chat. They get a prompt that shows which keys accept and decline the challenge, unless they are in combat, have PvP on or are otherwise busy, in which case you are told why. A ring is marked out on the ground, a short countdown runs, and the fight begins. Whoever runs out of health yields instead of dying. When the duel ends, both fighters get some health back and their harmful effects are cleared, and a card shows damage dealt and taken, hits and how long it lasted. Hold Backspace to give up.

Only your opponent's hits are made safe, including the fire and poison they leave on you. Creatures, falls and drowning can still kill you, and a duel cannot be started with anything hostile around the ring. Leaving the ring once the fight has begun counts as yielding, and a disconnect or crash ends every protection on its own within a few seconds.

AI notice

Most of Sparring was written by Claude Code (Anthropic), which did the heavy lifting on implementation and design. Heads-up so you can judge for yourself.

Commands

Add a number to /duel to set the ring size in metres. /duel rematch challenges your last opponent, /duel preview draws a ring where you stand, and /duel status shows what is going on. Accepting, declining and yielding also work from chat with /duel accept, /duel decline and /duel yield.

Multiplayer

Both fighters need Sparring. Nobody else does. On a server running Sparring, the server's duel rules apply to everyone, while keys and display options stay your own. Players without the mod can still join.

Settings

All settings are in BepInEx/config/isimp.Sparring.cfg, each with a description.

More

Technical notes and build instructions are on GitHub at

安裝與使用 安裝:BepInEx 外掛

  1. 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
  2. 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
  3. 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
  4. 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。

帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時,主機與所有用戶端需要安裝一致的模組。

前置依賴

下面這些內容需要先安裝,否則該模組不會生效:

denikson-BepInExPack_Valheim

檔案與校驗

檔案名稱
Sparring-0.2.1.zip
檔案大小
132.3 KiB