SidewaysHealthBar
Horizontal health bar above stamina/Eitr that grows from the middle, plus current/max values on stamina and Eitr.
模組介紹 作者原文
Sideways Health Bar
Adds a horizontal health bar above the stamina and Eitr bars.
- The health bar shows current / max health.
- Like the stamina and Eitr bars, it grows evenly from the middle to both sides when food increases your max health.
- The stamina and Eitr bars now show current / max instead of only the current value.
Configuration
Config file: BepInEx/config/rainb.SidewaysHealthBar.cfg (generated on first launch).
| Setting | Default | Description |
| --- | --- | --- |
| Health bar / Enabled | true | Show the sideways health bar. |
| Health bar / Width multiplier | 1 | Scales the health bar width (0.25 - 5). Same scale as the stamina bar at 1. |
| Health bar / Height multiplier | 1 | Scales the bar height (0.25 - 4). |
| Health bar / Vertical gap | 4 | Gap in pixels between the stamina/Eitr bars and the health bar. Only used when the health bar anchor is BottomCenter. |
| Health bar / Anchor | BottomCenter | Screen position to snap to (see below). |
| Health bar / Horizontal offset, Vertical offset | 0 | Moves the bar from its anchor, in pixels (-3000 to 3000). |
| Original health bar / Show | true | Show the original vertical health bar on the left. Food icons are not affected. |
| Stamina bar / Height multiplier | 1 | Scales the bar height (0.25 - 4). |
| Stamina bar / Anchor | BottomCenter | Screen position to snap to (see below). |
| Stamina bar / Horizontal offset, Vertical offset | 0 | Moves the bar from its anchor, in pixels (-3000 to 3000). |
| Stamina bar / Always visible | false | Keep the stamina bar on screen when full and unused. |
| Eitr bar / Height multiplier | 1 | Scales the bar height (0.25 - 4). |
| Eitr bar / Anchor | BottomCenter | Screen position to snap to (see below). |
| Eitr bar / Horizontal offset, Vertical offset | 0 | Moves the bar from its anchor, in pixels (-3000 to 3000). |
| Eitr bar / Always visible | false | Keep the Eitr bar on screen when full and unused. Stays hidden while max Eitr is 0. |
Anchors
Each bar can snap to TopLeft, TopCenter, TopRight, MiddleLeft, MiddleCenter, MiddleRight, BottomLeft, BottomCenter or BottomRight. Offsets are applied on top of the snapped position.
BottomCenter is the vanilla position. For the health bar it means "above the stamina/Eitr bars", so it follows their position and height. If you move the stamina/Eitr bars elsewhere, give the health bar an anchor too.
Other mods that move or resize HUD elements may change the bar positions; use the offsets to adjust.
Client-side only; not required on servers.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時，主機與所有用戶端需要安裝一致的模組。
下面這些內容需要先安裝，否則該模組不會生效：