LoxWagon

版本 v0.11.0·更新於 2026-10-01

Lox-drawn Cargo and Nomad Wagons with staged storage, a furnished cabin, bed, workbench, cartography and lanterns. Public singleplayer testing; pre-1.0. Multiplayer is not supported.

模組介紹 作者原文

LoxWagon

Build a lox-drawn cargo carrier or a covered travelling camp using Valheim's native models and materials.

0.11.0 is a public testing release. LoxWagon is pre-1.0 and intended for continued singleplayer testing. Multiplayer is unverified and is not supported for this release.

| | Cargo Wagon | Nomad Wagon |

| --- | --- | --- |

| Storage | 32 slots, 8 × 4 | 24 slots, 6 × 4 |

| Maximum health | 1,200 | 3,600 |

| Default empty mass | 65 | 100 |

| Passenger seats | Two front, one rear | Two front |

| Equipment | Visible crates, barrels and a full-load hide cover | Covered cabin, bed, workbench, cartography table, lanterns and spare wheel |

Both wagons have an articulated four-wheel chassis, a tamed-lox hitch, configurable cargo weight and optional flotation. Their visible cargo changes with the number of occupied inventory slots.

New in 0.11.0

The exterior shield now faces outward correctly. Starboard exterior cargo, including the spare wheel and its attachments, sits slightly farther aft; the shield stays in its existing location.

The spare wheel sits farther clear of the unchanged canopy, slightly lower and with a gentle hanging lean. Rounded rope cradles replace the angular lashings. The wheel now responds to travel with the same restrained sway as the other exterior cargo, while its rail hitches stay fixed.

Cover-aware snow, hitched boarding and Lie Down, the permanent cartography table, pale lox-pelt borders and simpler rolled ends carry forward from 0.10.9. Storage, recipes, mass and saved controls are unchanged.

Installation

Install Mod Manager or r2modman, including these dependencies:

  • BepInExPack Valheim 5.4.2351
  • Jötunn 2.30.2

For a manual installation, install the dependencies and place LoxWagon.dll in Valheim/BepInEx/plugins. Keep only one copy of the DLL installed. Launch the game once to create BepInEx/config/greypoint.loxwagon.cfg.

Building a wagon

Both Cargo Wagon and Nomad Wagon appear in the Hammer menu. Neither requires a crafting station. Construction materials are recoverable through normal dismantling.

| Material | Cargo Wagon | Nomad Wagon |

| --- | ---: | ---: |

| Fine Wood | 80 | 120 |

| Core Wood | 30 | 80 |

| Iron Nails | 80 | 160 |

| Barrel Hoops | 4 | 8 |

| Lox Pelts | 16 | 24 |

| Linen Thread | 8 | 24 |

Hitching and riding

  • Bring a tamed lox to the front of the wagon.
  • Aim at either wooden shaft or the central hitch and press Use to attach it.
  • Mount the lox with its normal saddle and ride to pull the wagon.
  • Use a shaft or the central hitch again to detach.

Passengers can use the bench seats. To enter the upright Nomad cabin, jump onto the rear steps or use Climb Aboard. Unhitching is not required.

If a wagon overturns, detach the puller and have passengers dismount. Aim at the wagon and follow Right wagon, using alternate place + Use, normally Left Shift + E. Recovery needs enough space and reasonably level, solid ground. It preserves cargo and damage and leaves the wagon detached.

Using the Nomad Wagon

  • Inventory: use the wooden chest just inside the rear opening on the workbench side. It opens the wagon's single 24-slot hold.
  • Workbench: craft, repair and build within its normal station range. Nearby workbench upgrades can improve it.
  • Bed: stop and unhitch, then use the bed to sleep. Alternate place + Use lets you lie down while hitched without skipping the night. Normal night, fire, enemy and wetness checks apply to sleeping. Your respawn point stays unchanged.
  • Cartography: use the red ink bowl to record discoveries, or the map to read shared discoveries. Map data is saved separately for each wagon, independently of its inventory.
  • Lanterns: turn the interior and rear lanterns on or off independently. They need no fuel and do not provide campfire heat.
  • Cover: use the rolled hide over the rear opening to hide or restore the roof and front covering together.
  • Banner: use the end of the skinny upper starboard pole to cy

安裝與使用 安裝:BepInEx 外掛

  1. 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
  2. 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
  3. 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
  4. 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。

帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時,主機與所有用戶端需要安裝一致的模組。

前置依賴

下面這些內容需要先安裝,否則該模組不會生效:

denikson-BepInExPack_ValheimValheimModding-Jotunn

檔案與校驗

檔案名稱
LoxWagon-0.11.0.zip
檔案大小
4.1 MiB