IAmClanka
Attaches loud plate metal clanking sound effects to player movements when certain (configurable) chest or leg armor pieces are equipped. By default applies only to some modded armors.
模組介紹 作者原文
Adds metal clanking sound effects to player movements when configured chest and leg armor pieces are equipped.
Config (ReepusDelmeepus.IAmClanka.cfg) is client-side, and accepts a comma-separated list of armor prefab item names. Most heavy armors from Jude's Equipment and some sets from Southsil's armor pack are listed by default.
If any one of the armor items from this list is equipped on a player, they'll get clanked.
Changelog
0.0.14
- updated for latest patch
0.0.13
- compatibility with Chaos Armor 10.5.0, which has built-in clanking effects
- should avoid duplication of sfx when this plugin is also installed- deleting and regenerating ReepusDelmeepus.IAmClanka.cfg is recommended just in case
0.0.11
- made bootstep sfx slightly more noticeable under the metal clanking
- added some new sets from southsil armor to default-generated cfg list
0.0.10
- adjusted sfx audio levels
0.0.9
- added a layer of heavy bootstep sounds under the clank
0.0.8
- added more sets from southsil armor into default list
- introduced very minor (probably unnoticeable) pitch and volume variation to all sound effects
0.0.7
- added all heavy sets in Jude's Equipment from iron and upwards to default list
- added small case handling to make climbing have the same loud footsteps as sprinting
0.0.6
- added bronze tier of chaos armor to default list, also stuff from southsil armor pack (I think at least)
0.0.5
- further reduced footstep effect volume
0.0.4
- tweaked footstep effect again, added a slight chainmail jingling component to it
- cleaned out some unused crap from underlying code
0.0.3
- adjusted volume of sound effects again, changed footstep out for something less sharp
0.0.2
- reduced volume of all sound effects slightly, were previously drowning out vanilla sfx too much
- attached proper audiomixergroup to sound effects (no longer muffled when indoors)
0.0.1
- initial release
安裝與使用 安裝:BepInEx 外掛
- 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
- 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時,主機與所有用戶端需要安裝一致的模組。
下面這些內容需要先安裝,否則該模組不會生效: