Hotkey Helper
Shows your mods' hotkeys in the vanilla key hint panels when they matter (building, combat, inventory, containers, fishing). Hold Alt+H to list every mod hotkey.
模組介紹 作者原文
Hotkey Helper
Mods add lots of hotkeys and you forget them. Hotkey Helper finds every hotkey in your installed mods' configs and shows the relevant ones in a small column on the right side of the screen, next to Valheim's own key hints:
| Situation | Mod hotkeys shown |
|---|---|
| Holding a hammer/hoe/cultivator | build (plus build-menu keys while the piece menu is open) |
| Holding a weapon | combat |
| Inventory open | inventory |
| Chest open | inventory + container |
| Fishing rod | fishing |
| Radial menu | radial |
Hold Left Alt + H to see a list of every mod hotkey, grouped by mod.
Client-side only. No Jötunn needed. The column follows the vanilla Key hints setting.
How it decides where a hotkey belongs
- Your override (see below)
- Built-in defaults for some popular mods
- A guess from the hotkey's name/section/description (e.g. "snap", "build" → build; "chest", "dump" → container)
Anything it can't place only appears in the Alt+H list.
Configuration
BepInEx/config/com.mous.hotkeyhelper.cfg (or in-game with ConfigurationManager):
- Enabled, MaxRows, ShowAllKey
- ColumnPosition (while building/fighting) and InventoryColumnPosition (while inventory, chest or crafting is open) — screen fractions, 0..1
- ColumnFontSize, OverlayFontSize
- For every discovered hotkey there is an entry under Hotkeys -:
- auto (default) – use the guess (shown in the entry's description)
- hidden – never show
- build,combat – comma list of: build, buildmenu, combat, inventory, container, fishing, radial, general
- add;Label to rename it, e.g. build;Cycle snap point
Entries appear after you load into a world once. Rebinding a mod's key updates the hints right away.
Notes
Only hotkeys a mod stores in its BepInEx config (KeyboardShortcut or KeyCode) can be found; hardcoded keys cannot.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時，主機與所有用戶端需要安裝一致的模組。
下面這些內容需要先安裝，否則該模組不會生效：