HearthFix
Fixes newly placed fireplaces and wisp torches not lighting when NoSmokeSimplified or NoSmokeStayLit is installed.
模組介紹 作者原文
HearthFix
HearthFix fixes a bug where newly placed fireplaces and wisp torches fail to light when NoSmokeSimplified or NoSmokeStayLit is installed. Affected pieces appear placed but never start burning, requiring a relog or world reload to fix.
Problem
NoSmokeSimplified and NoSmokeStayLit patch Fireplace.IsBurning to check the ZDO "fuel" key directly. For a freshly placed fireplace, that key hasn't been written yet — GetFloat("fuel", 0f) returns 0, so IsBurning incorrectly returns false. This affects hearths, campfires, and wisp torches (piece_demister).
Valheim Plus FireSource with infinite fires enabled has the same effect: V+ stops fuel consumption but never writes a positive fuel value, keeping fuel at 0 indefinitely.
Fix
A Postfix on Fireplace.IsBurning runs at Priority.Low — after the other mods' patches. It detects the absent fuel key via a -1 sentinel and restores IsBurning = true for newly placed pieces. It also checks the V+ FireSource config via reflection and does the same when infinite fires is active.
Compatibility
- Soft dependency on NoSmokeSimplified, NoSmokeStayLit, and Valheim Plus — loads and works correctly regardless of which are installed
- Client-side only
- No Jotunn required
Installation
Install or drop Narolith.HearthFix.dll into your BepInEx plugins folder.
Support
If you encounter any issues or have suggestions, open an issue on the GitHub repository.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時，主機與所有用戶端需要安裝一致的模組。