DadsPermadeath
Deletes the active character and locally hosted world on death, then returns to the main menu.
模組介紹 作者原文
DadsPermadeath
DadsPermadeath adds a confirmed Permadeath preset to Valheim's World Modifiers screen. When the local player dies in a world saved with this modifier, the mod removes every primary and backup save file associated with the active character, removes every primary and backup save file associated with the locally hosted world, and returns to Valheim's main menu without saving during shutdown.
Behavior
- Adds a DadsPermadeath button after Valheim's standard world modifier presets.
- Requires a Yes or No confirmation before selection.
- Saves Permadeath as a world-specific modifier only when Done is pressed.
- Keeps the selected standard preset and custom settings when Permadeath is confirmed.
- Shows Permadeath for default settings and Permadeath+ for any additional modifier; worlds without Permadeath retain Valheim's standard summaries.
- Selecting No clears Permadeath and restores the Normal preset.
- Activates only for the local player's death in a world with the modifier.
- Deletes local and cloud variants exposed through Valheim's save system.
- Deletes primary files and automatic backups for the active character and world.
- Waits for an in-progress world save to finish before deletion.
- Blocks character and world saves after death is detected.
- Shuts down the session without saving before file removal.
- Returns directly to the main menu instead of respawning.
- In a remotely hosted multiplayer world, deletes the local character and exits; only the host can remove the remote world save.
Configuration
- Mod Enabled: enables or disables DadsPermadeath.
Configuration path: BepInEx/config/com.dadisbored.dadspermadeath.cfg.
Installation
Install BepInExPack for Valheim, then place DadsPermadeath.dll in BepInEx/plugins/DadsPermadeath.
Compatibility
- Built against Valheim 1.0.12.
- Requires BepInEx only.
- Install on the client running the character.
安裝與使用 安裝:BepInEx 外掛
- 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
- 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時,主機與所有用戶端需要安裝一致的模組。
下面這些內容需要先安裝,否則該模組不會生效: