CraftFromChests
Craft, build, and fuel smelters/kilns using materials from nearby chests, without moving them into your own inventory. Also fixes the crafting/building UI to show the correct available amount.
模組介紹 作者原文
Craft From Chests
Craft and refuel from nearby chests, without emptying them into your own inventory first.
Features
- Crafting: at any crafting station, materials sitting in nearby chests count
towards a recipe's requirements, just like they were in your own inventory.
- Building: in hammer/placement mode, pieces you can afford using chest
materials are placeable and shown as available, exactly like carrying the
materials yourself.
- Correct UI: the crafting and building requirement panels show the real
total (inventory + chests) as "needed/total", e.g. 8/200, and no longer
flash red when you actually have enough.
- Smelters, kilns & blast furnaces: press the ore/fuel button and the mod will
pull a unit from a nearby chest if you're not carrying any yourself.
- Configurable range: how far the mod looks for chests is a normal BepInEx
config option (default 40 meters).
Only chests you have access to are used (the same permission check the game itself
uses when you try to open one), so locked/private chests are correctly ignored.
v0.4.0: fixed a crash that could interrupt the building menu's update loop
(and block placing pieces) when a chest without a fully initialized inventory
was nearby, e.g. a placement ghost.
Installation
- Install BepInEx
if you haven't already.
- Drop CraftFromChests.dll into BepInEx/plugins.
- Start the game.
Configuration
After the first run, edit BepInEx/config/toxo.craftfromchests.cfg
(or use a config manager mod in-game) to change SearchRadius (1–100 meters,
default 40).
Compatibility
Client-side only mod that patches how crafting/building/smelting requirements are checked.
Works in single player and multiplayer (each player needs it installed to benefit
from it themselves).
安裝與使用 安裝:BepInEx 外掛
- 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
- 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時,主機與所有用戶端需要安裝一致的模組。
下面這些內容需要先安裝,否則該模組不會生效: