ChestGrid
Snaps normal wooden chests into clean rows, blocks, and stacks while placing them with the hammer.
模組介紹 作者原文
ChestGrid
ChestGrid is a small Valheim BepInEx mod that snaps normal wooden chests into clean rows, blocks, and stacked layouts while placing them with the hammer.
Status
This is an early release and has not been broadly tested yet. Please treat it as experimental and make a backup of important worlds before using it on a server or long-running world.
AI Disclosure
This mod and package were created with AI assistance. OpenAI Codex was used to help generate code, package structure, and documentation.
Features
- Snaps normal wooden chests to nearby normal wooden chests while placing.
- Supports rows, blocks, and vertical stacks.
- Tuned default spacing for tight wooden chest layouts.
- Configurable grid spacing, snap range, vertical snap behavior, and cache interval.
- Hold Shift to temporarily disable snapping.
- Client-side only. The server does not need this mod.
- No runtime dependency on other placement or snapping mods.
Installation
Install with r2modman or Mod Manager.
For manual installation, place ChestGrid.dll in:
BepInEx/plugins/ChestGrid/
Configuration
After first launch, edit:
BepInEx/config/ChestGrid.cfg
Important values:
- GridWidth
- GridDepth
- GridHeight
- SnapRange
- VerticalSnapRange
- UsePlacementHeightForVerticalSnap
- DisableWhileShiftHeld
- ChestCacheInterval
Notes
- ChestGrid only affects placement previews for normal wooden chests.
- Existing chests are not moved automatically.
- If snapping feels too aggressive, hold Shift while placing or lower SnapRange.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時，主機與所有用戶端需要安裝一致的模組。
下面這些內容需要先安裝，否則該模組不會生效：