BuildRadiusCustomizer
Adjust build radius zones for your Workbench, Forge, Stonecutter, Black Forge, and Galdr Table. Fully synchronized via ServerSync.
模組介紹 作者原文
BuildRadiusCustomizer
A lightweight, completely dynamic utility that lets you customize the effective build radius of your Workbenches and Stonecutters on the fly using standard configuration sliders.
🛠️ Features
- Dynamic Range Sliders: Scale your build zones seamlessly from vanilla defaults up to massive building territories.
- Live Refresh System: Change the radius on the fly using the configuration manager. The active build circles update instantly without needing to restart your game client.
- Independent Controls: Configure the Workbench and Stonecutter ranges separately to fit your specific base-building setup.
⚙️ Requirements
- BepInEx pack for Valheim
- Official BepInEx Configuration Manager (Highly recommended to gain access to the interactive UI sliders inside the game via the F1 or Pause hotkey).
🚀 Installation
- Move the BuildRadiusCustomizer.dll file directly into your game's Valheim/BepInEx/plugins/ folder.
- Launch the game and access the settings panel via your configuration manager hotkey.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時，主機與所有用戶端需要安裝一致的模組。
前置依賴
下面這些內容需要先安裝，否則該模組不會生效：
denikson-BepInExPack_Valheim