BeeFree
Beehives produce honey anywhere - any biome, indoors, underground, even fully covered - and hold double the honey. Configurable.
模組介紹 作者原文
BeeFree
Free your bees. Vanilla beehives only make honey out in the open, in the right biome, with clear space above them - so a hive tucked inside your house, in a cellar, in a dungeon, or in the wrong biome just sits there empty. BeeFree lets a hive produce honey anywhere: any biome, indoors, underground, and even fully walled in or roofed over.
On top of that, each hive holds more honey while producing - double the vanilla amount by default - so you empty them less often.
Config
Config file: BepInEx/config/BeeFree.cfg
- Enabled (default true) - master switch.
- ProduceAnywhere (default true) - let hives make honey in any biome and while covered/indoors/underground.
- HoneyCapacityPercent (default 200) - how much honey a hive can hold, as a percentage of the vanilla maximum. 200 = double. Applied when each hive loads.
Notes
Requires BepInEx. Client-side, so in multiplayer it only affects players who have it installed. HoneyCapacityPercent takes effect as hives load, so already-loaded hives update after you revisit them.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時，主機與所有用戶端需要安裝一致的模組。
下面這些內容需要先安裝，否則該模組不會生效：