AttackCancel
Instantly cancel attacks into vanilla block or dodge transitions. Block-only cancellation ends the attack immediately; Block+Jump uses Valheim's normal dodge behavior.
模組介紹 作者原文
Attack Cancel/Counter
Instantly cancel an active attack into Valheim's normal defensive controls.
Features
- Press Block during an attack to immediately cancel the attack and enter the normal block/parry state.
- Press Block + Jump during an attack to immediately cancel the attack and perform Valheim's normal directional dodge.
- Does not add a separate dodge control.
- Debug logging is disabled by default.
- No configuration is required for normal use.
Requirements
- Valheim 1.0.x
- BepInExPack Valheim 5.4.2350 or newer compatible release
Installation
Install Mod Manager, r2modman, Gale, or extract the package into your Valheim profile.
The plugin is installed as:
BepInEx/plugins/AttackCancel/AttackCancel.dll
Configuration
After first launch, BepInEx creates BepInEx/config/AttackCancel.cfg.
General / Mod Enabled — enables or disables the mod.
Debug / Debug Messages — enables diagnostic messages. Default: false.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。 多人連線時，主機與所有用戶端需要安裝一致的模組。
前置依賴
下面這些內容需要先安裝，否則該模組不會生效：
denikson-BepInExPack_Valheim