GravityController

版本 v1.0.1·更新於 2026-02-27

Allows full control of gravity. Go upsidedown, to the side, anywhere.

模組介紹 作者原文

GRAVITY CONTROLLER

This mod allows precise control of gravity on the player, allowing users to customize the amount of force applied to them and the direction gravity can travel. This means you can now technically play the game upside-down.

How it works

This mod takes the gravity direction inputted in the config and multiplies it by an inputted multiplier times 40 (the default gravity for the player), then assigns that gravity to the player.

Configs

Note: Configs are handled by Configgy mod.

Mod controls

Controls for how the mod functions and operates.

  • `Mod Enabled`: Enable / disable the mod.
  • `Debug Info`: Logs debug info, I don't recommend enabling this

Gravity Direction

These settings control the normalized direction of gravity. Them being normalized means that a value of 1 will mean that the gravity will point in the direction along its specified axis. For example, a direction of (X:1, Y:0, Z:0) will send the player flying left along the x axis, however a direction of (X:1, Y:1, Z:0) will send the player flying left and downwards at a 45 degree angle.

  • `X Direction`: Controls the normalized direction of gravity on the X axis
  • `Y Direction`: Controls the normalized direction of gravity on the Y axis
  • `Z Direction`: Controls the normalized direction of gravity on the Z axis

Gravity Multipliers

These settings control how strong gravity is along a specified axis. This means that a gravity of (X:0, Y:0.5, Z:0) will make the player have a lower gravity (assuming the Y direction is equal to 1). In addition, negative gravity multipliers will flip the direction of gravity, so a gravity multiplier of (X: 0, Y:-1, Z:0) will make the player fall upwards.

  • `X Multiplier`: Controls how strong gravity is on the X axis.
  • `Y Multiplier`: Controls how strong gravity is on the Y axis.
  • `Z Multiplier`: Controls how strong gravity is on the Z axis.

Known Issues

When starting the game, some errors are spit out, these probably don't do anything.

Slam storage is broken when gravity has been reversed, this isn't my fault and I also can't do anything about it. sorry:)

If you encounter any errors, message me on discord

安裝與使用 安裝:BepInEx 外掛

  1. 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
  2. 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
  3. 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
  4. 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。

帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。

前置依賴

下面這些內容需要先安裝,否則該模組不會生效:

BepInEx-BepInExPackHydraxous-Configgy

檔案與校驗

檔案名稱
GravityController-1.0.1.zip
檔案大小
125.2 KiB