Propeller

版本 v1.2.1·更新於 2026-10-08

Adds installable propellers and paired control panels sold at Al'Ankh Academy, with adjustable power, wheel throttle controls, and water or air propulsion.

模組介紹 作者原文

Propeller

Disclaimer: This mod is made with ChatGPT 6.0 Astra

Astonding technology breakthrough from Al'Ankh Academy!

(it means it's very cheaty)

Propeller and control panel

  • Both item are now sold at Al'Ankh Academy vendor. It's VERY expensive.
  • Attach the propeller and control panel to the postion of your liking, then hammer it to install. Before hammered it won't be able to work.
  • Control panel will automatically pair with the propeller installed after hammered.
  • If you reuse the propeller on other boat, after you hammer the control panel and try to switch it on, there will be a small window to comfrim your current propeller pairing.
  • Position of where propeller attached matter! It will create torque depend on where you install it on hull.
  • Vanilla ship's Center of Mass is usually at the keel, so lower the propeller, more stable it will be.
  • You can use this to create turning force, lifting force or diving force.
  • It's possible to make air ship if you place and control the propeller correctly.
  • Control panel got following function:
  • Power switch: On/off
  • Water Switch: Water/Air
  • It control if propeller need to be submerged in water to produce propulsion. If switch to Air it will work everywhere, even submerged.
  • Engine Power: 5-100.
  • Use the arrow below to control the power.
  • Wheel Control: after click, make wheel control this propeller's throttle
  • Safety Switch: When On, Power will be shut off automatically when you exit the boat.
  • Throttle meter: Show current throttle.
  • Press W/S while holding wheel to increase/decrease throttle.
  • You can install multiple propeller on same boat. There is no limit, but each panel only pair with 1 propeller.
  • The force will stack, so putting on 3 propeller is faster than 1.
  • 3 option in configurator
  • Offset: control the thrust vertical offset
  • Trim Angle: Control the bow lifting angle for propulsion.
  • Show Marker: Show Center of Mass and propeller thrust force location

安裝與使用 安裝:按包內說明操作

  1. 解壓本站下載的壓縮包,先讀包內的 readme / 說明檔案。
  2. 多數模組依賴遊戲的模組載入器:常見做法是用社群模組管理器(如 r2modman)選中本遊戲安裝,由管理器自動處理載入器與依賴。
  3. 手動安裝時,把模組檔案放進遊戲目錄下對應的 Mod / plugins 資料夾。
  4. 啟動遊戲確認載入成功;帶「前置依賴」的模組需要把依賴一併安裝。

不同模組的安裝位置差異較大,包內說明是最可靠的依據。

前置依賴

下面這些內容需要先安裝,否則該模組不會生效:

BepInEx-BepInExPack

檔案與校驗

檔案名稱
Propeller-1.2.1.zip
檔案大小
4.5 MiB