TMFBalancedInteractables
Attempts to balance the spawnrates of Printers & Lunarpods when playing with TMF
模組介紹 作者原文
TMFBalancedInteractables
Attempts to balance the spawn of certain interactables when using TMF in RoR2.
One thing I noticed after playing with too many friends was the sheer quantity of "good" 3d printers, which made the game feel way too easy. Thus, this is my solution.
Installation:
Requires Bepinex, R2API. TMF suggested - does not modify spawnrates for <=4 players.
Place inside of Risk of Rain 2/Bepinex/Plugins/
Configuration:
By default, the config printerScalar is set to 1. This provides base scaling such that the more players that join, 3D printers and lunar pods will decrease proportionally.
With a 1.0 printerScalar, at 4 players, the weight of 3D printer spawns is 100% of vanilla. At 8 players, it is 50% of vanilla. at 16 players, it is 25% of vanilla.
printerScalar is a scalar upon the modified weight of printer spawns. This means that 8 players with a 2.0 value is the same as playing vanilla. 16 players with a 4.0 value is the same as playing vanilla.
printerScalar is inteded to act as a scalar for fine tuning where the player scaling may not be precisely accurate for the prefrences of the host/group. My advice is to keep between a range of 0-4 for decreasing spawns; anything above this will definitely increase spawn rate for any amount of players.
use "printerScalar {(double)value}" in console to change scalar on next map.
Changelog
v1.0.1 - Implemented console command.
v1.0.0 - Released.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝，否則該模組不會生效：