TidyAllies
Folds turret and drone ally cards into small health icons on their owner's card, and shows HP numbers on every card.
截圖 共 1 張
模組介紹 作者原文
TidyAllies
Turrets and drones no longer push your party off the screen.
Every minion you own -- turrets, drones, Beetle Guards, Squid Polyps -- normally
gets its own ally card. Bring a few and the left side of your screen fills up.
TidyAllies folds them into a row of small icons underneath their owner's card.
Each icon is that minion's own portrait, and it drains from the bottom as the
minion loses health, so you can still tell at a glance which one is about to
die. One card per player, however many minions they are dragging around.
What else changed
- Your own card is shown. The vanilla HUD only lists other players, so
playing solo left you with nothing but a stack of drone cards.
- HP numbers on every card, with the percentage next to them. Same values as
the health bar in the corner of your screen, down to how shields are counted.
- Cards match the HUD. Same trapezoid tilt as the rest of the interface, and
the background fades out toward the right edge.
- Spacing. Cards no longer overlap when the party is full, and the contents
are no longer glued to the edge of the panel.
Only you need it
This is a display mod. It reads nothing over the network and writes nothing --
hideAllyCard is a SyncVar and is deliberately left alone. Install it on your
own game and it works whether you host or join, with or without other people
running it.
Configuration
Everything is adjustable in-game through Risk of Options, or in
BepInEx/config/OchaDashiMan.TidyAllies.cfg.
| | |
|---|---|
| Icon Size / Spacing | how big the minion icons are and how far apart |
| Icon Area Width | how much width they may use before they start overlapping |
| Card Padding | gap between the card background and its contents |
| Player Gap | gap between one player's card and the next |
| Colours | fill, drained, and the low-health tint |
| Show Self | turn your own card back off |
| Enabled | turn everything off and get the vanilla cards back |
When you have more minions than fit, the icons overlap rather than being cut
off, the same way vanilla stacks cards when the party is large. Nothing you own
disappears from the display.
Compatibility
Requires nothing beyond BepInEx. Risk of Options is optional and only adds the
in-game settings menu. Mods that replace the HUD wholesale may conflict.
License
MIT
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝，否則該模組不會生效：