FixedFlyIonSurge
Makes Artificer's Ion Surge scale with base speed instead of movement items. Fully configurable jump height (0.5 to 5.0)!
模組介紹 作者原文
Fixed Fly Height Ion Surge
changes Artificer's Ion Surge utility skill height and makes it not scale with movement speed, fixed value instead.
What it does:
Normally, the height of the flight scales with your current item-boosted movement speed, which can launch you into orbit in late-game stages.
This mod forces the skill to calculate height using Artificer's base movement speed, keeping the jump height consistent throughout the run.
Configuration:
You can customize the jump height directly in r2modman's Config Editor (or by editing Masosu.FixedFlyIonSurge.cfg inside your BepInEx/config folder).
- JumpMultiplier: Adjusts the multiplier of the jump.
Default*: 1.0 (standard base-speed jump)
Allowed Range*: 0.5 to 5.0
Note*: Decimals must use a dot (.), not a comma (e.g., use 1.5, not 1,5).
Requirements:
- BepInExPack
- HookGenPatcher
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝，否則該模組不會生效：