ArtiTweaks
Configurable tweaks for Artificer
模組介紹 作者原文
ArtiTweaks
| Info | Installation | Configuration | Changelog |
|---|---|---|---|
Configurable tweaks for Artificer.
Info
- M2 no longer cancels sprint
- Toggleable
- Flamethrower Range increased by a factor of 1.7
- Configurable/Toggleable
- Doesn't affect visuals, just the hitbox
- Ion Surge Height slightly reduced to 0.95 (to help you stay in tele)
- Configurable/Toggleable
- Rate at which Jetpack slows your fall increased by a factor of 2
- Configurable/Toggleable
- Add IonSurge to Utility
- Toggleable
- Special version remains to allow for Vanilla Loadouts.
- Yes, you can equip both if you really want
- Allow Infinitely Charging M2
- Toggleable
- Disabled By Default
- Does not affect very high attack speeds
- Allow Sprinting during Flamethrower
- Toggleable
- Disabled By Default
- Set the Gravity Coef for Arti NanoBomb/Corrupted Void Fiend Flood
- Configurable/Toggleable
- Disabled By Default, since it affects Void Fiend too
Installation
Put ArtiTweaks.dll inside the BepInEx/plugins folder.
Configuration
Run the game once to generate the config, then edit BepInEx/config/Foldex.ArtiTweaks.cfg
Changelog
1.1.0
- Added ability to change Ion Surge Height
- Added ability to change Jetpack Thrust
- Added ability to charge M2 Infinitely
1.0.0
- Initial Release
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
前置依賴
下面這些內容需要先安裝，否則該模組不會生效：
bbepis-BepInExPacktristanmcpherson-R2API