peakReconnect
Press a configurable key or controller button to reconnect to the last server you were in.
模組介紹 作者原文
Uses lobby join codes to reconnect, so make sure your friends have "lobby mode" set to "open to friends" in their general settings
you can't share a join code without this setting enabled, if you joined a lobby through a steam invite link, you're good to go already
if you don't join back in a couple seconds after pressing your kebind, the lobby might be gone, or you can try pressing the button again
you can configure the keybind to reconnect in the config, and the lobby code for the last room you were in is also saved there
changing binds will require a game restart, same if you want to manually put in a lobby code for whatever reason
I didn't test controller binds but they should probably work.
feel free to modify, rip, / do whatever
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝，否則該模組不會生效：