SlowerColds

版本 v1.0.0·更新於 2023-11-23

Adjusts cold (disease) proc system.

模組介紹 作者原文

Slower Colds

Slower Colds is maily intended to stop the annoying "instant" colds in Outward.

Outward has a very slow 2.5 minute (1 in game hour) check frequency for cold infections, which is probably why the chance is so high at 35%. The issue is that the first check usually happens immediately upon reaching the temperature threshold, meaning a fair amount of the time you will immediately catch a cold the moment you hit 40 temperature (Needs: Cold), which is a bit unrealistic and heavily punishes momentary temperature drops.

Slower Colds implements a more frequent check with a lower infection rate, smoothing out the curve, while also allowing minimum times before infection can happen. It checks for Needs: Cold or Needs: Very Cold instead of temperature, and uses the found status's age as timer.

The default values for Needs: Cold create a curve similar to vanilla without the sudden large front loaded jumps and a 30 second minimum, while Needs: Very Cold has twice the infection chance and no minimum time. Both check every 30 seconds instead of 150.

Config

Needs: Cold and Needs: Very Cold each can have their own values for the following:

  • Chance: percent chance of catching a cold
  • Min Time: minimum time before the first check
  • Check Frequency: how often to check again

安裝與使用 安裝:BepInEx 外掛

  1. 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
  2. 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
  3. 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
  4. 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。

帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。

前置依賴

下面這些內容需要先安裝,否則該模組不會生效:

BepInEx-BepInExPack_Outward

檔案與校驗

檔案名稱
SlowerColds-1.0.0.zip
檔案大小
64.8 KiB