ScrapLossBalancer
Change team death to lose a percentage of scrap, scaled by number of players.
模組介紹 作者原文
Scrap Loss Balancer
A host-only mod to balance the amount of scrap you lose after all players die. The intention is to make it feasible to continue playing after death while still having death be meaningful, unlike mods that disable scrap loss entirely.
By default, it scales by the number of players in the game, with 12.5% value lost per player.
The idea is that the more players you have, the easier survival is, and it should be less likely that everyone dies. This attempts to balance that so a single team death doesn't make the quota automatically impossible and force a /restart.
This should scale fine with mods such as MoreCompany, however I haven't tested it.
Features
- Host-only. Clients can have the mod installed, it just won't do anything.
- If you install a config mod like LethalConfig, configuration can be changed while playing. Changes take effect the next time everyone dies.
- Configurable settings:
- Enabled - To allow you to temporarily disable the mod for some games.
- Scrap Penalty (%) - The amount of scrap value lost, multiplied based on the calculation type.
- Calculation Type - Either PerPlayer or TotalPercent
Everyone will still see the "All Scrap Lost" message on death, even though it's not.
Explanation
If calculating PerPlayer, then when everyone dies, the mod will multiply the Scrap Penalty % by the number of players in the game, and then remove at least that much scrap.
For example, if you have a 4 player game, with the default 12.5% penalty, then when everyone dies it will try to remove 50% of scrap value from the ship. If you had 2000 scrap, it will remove at least 1000 scrap. It basically takes the largest scrap until it's close, then fills in the rest with the smallest pieces until it's over 1000. It's common you may end up a little extra if it doesn't add up exactly. So in this case, the team may end up with 995 scrap remaining on the ship.
If calculating TotalPercent, then the scrap penalty % is used as-is, and the number of players don't matter. In the same scenario above, the team would end up with 1750 scrap left, or a little less.
If you set the Scrap % to 0, it'll be the same as mods that disable scrap loss on death. Similarly, if the Scrap %
安裝與使用 安裝:BepInEx 外掛
- 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
- 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝,否則該模組不會生效: