LethalEscapeThrottle
A performance fix for LethalEscapeUpdated. Enemies that cannot reach an exit stop re-pathing and spamming the log every frame. On tricky navmesh moons this cuts the lag and thousands of log lines.
模組介紹 作者原文
LethalEscapeThrottle
A small performance fix for LethalEscapeUpdated.
On tricky navmesh moons, enemies that cannot reach an exit re-run their escape check every single frame. Each of those calls does a NavMesh path calculation and prints several log lines, so over a round it piles up into real frame-time cost and tens of thousands of log lines.
This mod adds a per-enemy cooldown, so a failed escape attempt is not retried until later. The wait is adaptive: an enemy that keeps failing backs off longer and longer (the wait doubles each failure, up to a cap), so a permanently boxed-out enemy stops burning frame time entirely. Enemies that can escape still succeed on the first try and are never throttled.
Config
- Enabled: toggle the throttle.
- CooldownSeconds: base wait (default 2.0) before an enemy that just failed retries its exit search.
- MaxBackoffSeconds: cap on how long the adaptive back-off can grow (default 15). Higher means less lag but slower to notice a newly opened path.
- DiagnosticLogging: log a short summary every 30 seconds (only when active) of how many exit searches were skipped versus run, so you can confirm the throttle is working. On by default; turn off for a quiet log.
Credits
Made by Pierre (Discord: samedude67). Requires LethalEscapeUpdated by woah25.
安裝與使用 安裝：BepInEx 外掛
- 本站下載的壓縮包就是模組本體，通常是 BepInEx 外掛（解壓後得到 .dll 或外掛資料夾）。
- 建議流程：用社群模組管理器（如 r2modman）選中本遊戲後匯入該模組，管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程：先在遊戲目錄裝好 BepInEx 載入器，再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲，BepInEx 控制台會列印載入日誌；確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝，否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝，否則該模組不會生效：