LethalCompanyHighlights
Record, clip, and annotate your Lethal Company deaths with Steam. Your incompetence, now professionally documented.
模組介紹 作者原文
Lethal Company Death Capture
Uses Steam's new Game Recording feature to capture your best deaths in service to the Company.
Requirements
You must manually enable Record in Background in the Steam client.
Set the quality settings to your preference, I use a 60 minute buffer at "High" quality.
That's it, you're done.
Recommendations
You should also turn on Record Microphone so that Steam will capture the despair as another Coil Head jumps out of nowhere for another sneak attack.
Automatic Gain Control may be useful but can produce crackly audio depending on your setup. If you plan to use this to capture clips long term, I recommend jumping into a save solo and testing with AGC on/off - this is the best we've got until Steam adds manual gain control.
Configuration
LethalConfig is used for configuring the mod, all options are realtime and do not require restarting the client to reflect the change.
By default, the Steam overlay will open after you die; there is a short delay to facilitate a more natural reaction to whatever caused your demise.
You can disable this behavior in the configuration menu if desired, just remember that if your recording length is low you will need to check and export any clips you wish to keep at some point.
This mod will also clip other people's deaths under certain conditions:
- You watched the other person die in spectator mode.
- You were in the immediate vicinity of a player who just died.
- You saw a person that died within the last 10 seconds.
See the v0.1.5 release notes for more information on how these work.
Capture Modes
There are two capture modes presently, I couldn't personally settle on which I preferred for clipping and so I included both options the Steam Timeline API currently supports.
"Clip" mode will create a gold line underneath the section of the recording where somebody died on the recording overlay, this allows for easier one-click clipping. This is the default for now, though unfortunately it doesn't seem like the death cause is visible for this mode.
"Marker" mode will create a little skull icon on the recording overlay, this is a bit easier to click on at the time of writing but does only captures a brief instant and thus you will need to adjust duration manually.
Searchable Clips
Additional metadata has been added to recordings to help you sift through the best bits, this includes the following information:
- The name of the planet you're exploring, as of v0.1.5 this has replaced the tooltip on the timeline.
- The Orbiting tooltip is still present before landing.
- Who participated in a round.
- Who died during a round, letting you finally catch out that one friend that never dies!
Other Features
Integration with Coroner attempts to use the same death message you see at the end of the level in the recording tooltip.
At the time of writing, the recording bar changes colour based on the state of the game too to indicate if, in a recording, you're in the menu, on the ship or exploring.
As Steam adjusts the "Timeline" API I will look into adding more detail.
安裝與使用 安裝:BepInEx 外掛
- 本站下載的壓縮包就是模組本體,通常是 BepInEx 外掛(解壓後得到 .dll 或外掛資料夾)。
- 建議流程:用社群模組管理器(如 r2modman)選中本遊戲後匯入該模組,管理器會自動裝好 BepInEx 前置並處理依賴。
- 手動流程:先在遊戲目錄裝好 BepInEx 載入器,再把解壓出的 .dll 或外掛資料夾放進 BepInEx/plugins/。
- 啟動遊戲,BepInEx 控制台會列印載入日誌;確認這個模組出現在日誌裡即為安裝成功。
帶「前置依賴」的模組需要一併安裝,否則不會載入。功能開關通常在遊戲內或外掛自帶的設定檔裡調整。
下面這些內容需要先安裝,否則該模組不會生效: